SMR Gearbox Installation
Satisfactory functionality depends upon suitable installation. lubrication and upkeep. hence it is necessary the directions during the set up and maintenance leaflet. provided with each gearbox. are followed cautiously. some of the crucial elements of belt and torque-arm set up are listed below.
1. Install pulley on gearbox input shaft as near for the reducer achievable, and mount reducer on driven shaft as close to bearing as practical. failure to perform this will result in excess loads in the input shaft bearings and output bearings and could bring about their premature failure.
two. Install motor and wedge belt drive together with the belt pull at somewhere around 
90° to your center line involving driven and input shafts. this can allow tensioning from the wedge belt drive with all the torque arm which need to ideally be in stress. if output hub runs anti-clockwise. torque arm need to be positioned the appropriate.
3. lnstall torque-arm fulcrum on the rigid assistance so that the torque-arm might be at about correct angles on the center line with the driven shaft and the torque arm case bolt. ensure that there may be enough consider up during the turnbuckle for belt tension adjustment.
Preserve shut.
Bell drive could possibly be found in any practical postion. if your torque arm would be to be applied to tighten the belts, the drive need to be at about tight angle to your line between the input and output shafts.
Bell drive may be positioned to your proper if preferred.
If output hub rotates clock-wise. position belt drive and torque arm in opposite path to that proven in the illustration.
Torque arm and belt consider up.
Torque arm might be mounted towards the ideal if sought after.