Power UNITS FOR LIFT TABLE 1
Common Description
This electrical power unit is made solely for the modest lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become extensively utilized during the business of logistic devices for instance minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is controlled from the solenoid valve with the pace managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Common Description
This electrical power unit is developed exclusively for the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and the speed managed from the adjustable needle valve. When the lift rises to a high positoin, however the power supply is reduce, the lowering motion is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE three
Standard Description
This energy unit is intended solely for that large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve along with the speed managed by a strain compensated flow management valve.
Power UNITS FOR LIFT TABLE 4
General Description
This electrical power unit is designed solely to the large lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and the pace managed from the adjustable needle valve. Once the lift rises to a high positoin, but the electrical power supply is cut, the reducing movement is controlled from the manual override perform.
Distinctive Notes
1. This energy unit is of S3 duty cycle, which may only operate intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean each of the hydraulic elements concerned before installation of the energy unit.
three. Viscosity on the oil shoud be 15~46 cst,which ought to also be clean and free of impurities.N46 hydraulic oil is recommended.
4. Oil changing is needed after the initial one hundred operation hours,afterwards the moment each 3000 hours.
5. The power unit shown is designed to be mounted vertically.