one.A connecting website link of an O-ring Chain for basic application is pre-coated with grease with the pins. Prior to connection, verify the grease on the surfaces of pins, and should the amount of grease is little, apply grease with bare hands. (If gloves are utilised, the grease will be absorbed from the gloves.)
Instance: When the connecting hyperlink (I) of an O-ring chain for standard application is
shipped, O-rings are fitted at the roots on the pins. When the O-rings come loose as a result of vibration all through transport, refit the O-rings in to your roots in the pins.
In this case, be sure to return the grease collected in the roots on the pins on the central surfaces on the pins, more at portion A than at portions B shown within the above illustration. (Portions A is worn due to sliding together with the bushings.)
two.The chain can be most simply linked over the teeth of a sprocket. Engage the hyperlinks at both ends from the chain with all the sprocket teeth and 
match connecting pins. If your sprocket could be moved, the chain can also be connected about the loosened side.
3. Connecting procedure
1.Confirm that O-rings are attached towards the roots of your pins.
two.In the event the level of grease utilized around the connecting pins is smaller, coat the pins with grease in the central portions.
three.Insert the connecting pins into the bushings on the inner links at both ends.
4.Verify that the grease is utilized towards the complete encounter on the O-ring, and match the O-ring onto the connecting pins.
5.Insert the connecting pins in to the connecting plate and even though pressing the connecting plate, set up the spring clip. Verify whether or not the head (the end with no split) with the spring clip is turned inside the feeding route of your chain. (See the following illustration.)
six.Make sure you confirm that the spring clip is securely fitted within the clip grooves in the connecting pins.
This completes jointing of the connecting link. Note that grease within the surfaces of connecting pins and O-rings is often removed throughout set up function. In this case, re-grease utilizing the grease to the surface from the base chain or even the grease from the polyethylene bag by which the connecting link was contained.